When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Basically cut out a ford crossmember got the axels at the same height and measured with string lines to get it senterd and tacked the crossmember in Lots of droop Plating/ bracing Covering up the ugly crossmember ends and strengthening
Looks like a great build. I'm looking forward to see this complete.
I've done a SAS as well.
Also, You will get more views from this post in the 1st generation Dakota Sub-section, not many people look at the general non-specific forum. I would sugest to start new thread in the 1st gen Dakota section or hopefully a moderator can move this there for you.
Dang...not knowing much about welding besides my very amateur ability with a FC...those look like damn nice welds. And a sweet project. Hope he comes back to post.