ABS Control Module
#1
#3
Nothing thats the problem. I had a new diagnostic tester hooked up to my obd2 port to try and find out the code as to why my break and abs light is on and the reader couldn't even get a signal from my abs control module. And i just want to know if anyone has had this problem or if there is a way to test the module for power
#4
#6
Try clearing it by disconnecting you battery for 30 seconds with the lights on. Then go back and see if the light still kicks on. If that doesn't work, get your Haynes manual and turn to page 9-24and read the "Diagnose and Repair" section. That ought to give you some more insight as to what's going on. Best of luck.
#7
the abs control module is a black box near master cylinder. might have kelsey hayes stamped or printed on it. there's likely a fuse for it, either under the hood or in the end of the dash. should be an electrical connector to it. you could gently probe the pins for power.
download the 01 service manual in the faq section. it has very good wiring diagrams in the back.
download the 01 service manual in the faq section. it has very good wiring diagrams in the back.
Trending Topics
#8
#9
#10