Multi Electrical Problems???
#1
Multi Electrical Problems???
I have a 96 Dodge Caravan and I seem to have a problem. The turn signals/hazards do not work, as well as the blower motor, the rear wiper, and the rear defrost.... I have checked all the fuses and the related relays... Everything seems good.
I did use a jumper wire to check the Really tall fuse under the dash and with the jumper wire everything would work when jumped. So I spent the $80 and got a new relay but that did nothing.
Anyone have any ideas what could do this?
I did use a jumper wire to check the Really tall fuse under the dash and with the jumper wire everything would work when jumped. So I spent the $80 and got a new relay but that did nothing.
Anyone have any ideas what could do this?
#2
#3
Join Date: Apr 2007
Location: Near Sacramento,ca
Posts: 11,545
Likes: 0
Received 92 Likes
on
78 Posts
Welcome to DF
I didn't see anywhere that you used either a DVOM or a 12 volt test light. Like 22dodge22 had said, could be fuse's which you said you checked. Could be an open circuit or a BCM. I would remove the relay for turn signal/ 4way flasher and ck for power and ground. And then the blower motor and the rear wiper the same way. And if you need some diagrams, I may still have some. I would need your email to send the diagrams.
I didn't see anywhere that you used either a DVOM or a 12 volt test light. Like 22dodge22 had said, could be fuse's which you said you checked. Could be an open circuit or a BCM. I would remove the relay for turn signal/ 4way flasher and ck for power and ground. And then the blower motor and the rear wiper the same way. And if you need some diagrams, I may still have some. I would need your email to send the diagrams.
#6
#7
I have checked all fuse's / Relays and have all the wireing diagrams , everything is checking out so far but still no power to any of the above mentioned , I even replaced the fusebox&computer under the dash.I did find out theat the Voltage regulator for the Blower was bad I am really getting blown away by this and the only other thing I can think to do is to tear all the wires apart and check each and everyone of them . starting to get really frustrated with the whole ordeal ! PLEASE HELP
Trending Topics
#9
This sounds like a key clue to your problem. Can you expand on what the "Really tall fuse" was. You then say you jumpered this "fuse", everything worked, so you replaced a relay. Why a relay after jumpering a fuse? Can you include contact numbers off the wiring diagrams you now have of exactly where you installed the jumper?
Last edited by Cougar41; 02-20-2011 at 10:17 PM.