Ok 4 months ago i had the trans rebuilt by some Joe shmoe who claimed to. Know what he was doing at 700 dollars I did not complain untill 5 days ago when it lost first and reverse so I pulled the tranny and brought it to the local transmission authority who pulled it apart and found that the clutches and drums where destroyed and none of the seals had been replaced so I dropped 1500 on the bench job and a sure cure shift kit he was done two days later slapped the tranny back in started it and it threw p0340 and "ran" like crap so I replaced the cam sensor and it did nothing so the plan for tomorrow is to inspect the crank sensor then move to the timing anything is possible I am not gentle when i work on my truck smashy smashy please post with comments and suggestions

 

P0340 No Cam Signal At PCM


Did your reset the PCM after replacing the sensor?

 

Yes I cleared the codes and reset the pcm

 

hay i guess turning the motor by sticking a wrench in the flex plate holes i bent it and it smashed the crank sensor ooooooops

 

yea, that would do it . . .

 

Ya that was the problem if your truck is barely running and detonating like crazy try a crank sensor

 

Next time I'll be gentle......er

 

LMAO


You be nicer to your truck!.......