a few dumb problems
#1
#2
do you have an air filter on it. if not that could be causing the carb whistling. have you checked the transmission fluid level while it is in neutral? sounds like your timing could be a tiny bit off. does it seem to get better as it warms up?
you should really fill out your info or sig so that i don't have to dig to find out that you have a 86 d100 with a 318.
you should really fill out your info or sig so that i don't have to dig to find out that you have a 86 d100 with a 318.
#5
#6
I would check the throttle rod (kick down linkage) adjustment first before I make any adjustment. Grab the rod near the carburetor and push it rearward then slowly release it. If it is properly adjusted and lubricated it will return to its full forward position on its own. The full forward position is when the rear of the slot in the carburetor link is up against the carburetor stud that it slides on. All moving parts must be well lubricated before adjustment. Make sure the truck is warm and it is off the high idle cam.
wontacceptthis: Just curious. How do you adjust a throttle cable?
wontacceptthis: Just curious. How do you adjust a throttle cable?
Last edited by SEAL; 04-07-2011 at 05:53 PM.
#7
Well. Your throttle cable most likely has stretched over the years. If you put a cinder block on the gas pedal and look at the throttle, it probably won't be the whole way open.
If you pull up on your gas pedal, you will notice it goes up a bit as the throttle cable pulls through it. So pull up the pedal and pull the cable towards you, taking out the slack. Then you either put a new ferrule on the end of the cable so it is the right length again, or you put washers or zip ties or something else between the pedal and the ferrule. This way your pedal will sit up a little bit higher. This time, when you put the cinder block on your gas pedal, the throttle will be open the whole way.
Since the throttle cable and kickdown linkage are tied together, I'm imagining only being able to run at half throttle would prevent your truck from downshifting.
If you pull up on your gas pedal, you will notice it goes up a bit as the throttle cable pulls through it. So pull up the pedal and pull the cable towards you, taking out the slack. Then you either put a new ferrule on the end of the cable so it is the right length again, or you put washers or zip ties or something else between the pedal and the ferrule. This way your pedal will sit up a little bit higher. This time, when you put the cinder block on your gas pedal, the throttle will be open the whole way.
Since the throttle cable and kickdown linkage are tied together, I'm imagining only being able to run at half throttle would prevent your truck from downshifting.
Trending Topics
#8
I understand and agree the cables stretch. I used washers to do mine. Just wanted to know how you did it.
I also prefer the term throttle rod instead of kick down linkage because that system controls both where any down shifting occurs and where the upshift happens much the same as a vacuum modulator.
I also prefer the term throttle rod instead of kick down linkage because that system controls both where any down shifting occurs and where the upshift happens much the same as a vacuum modulator.
#9
#10