I got my new to me tranny. Im looking forward to the ram being manual.

 

Checked the tracking number for my headers for the Camo Beast and they will be in on Tuesday.

 

I picked up new rear floor mats for the diesel and took a side trip to look at a rat rod in the area. K.

 

Where is mine?

Why is it a Ford?

 

I just started a thread for the upgrades that will be done to the Camo Beast this year, come check it out!


https://dodgeforum.com/forum/2nd-gen...ml#post3148642

 

Yours is in Indiana. The guy I got it from has more.

Its going behind a 4bt cummins, its a factory bolt up. Its allso $850 cheaper than an nv4500. I still need to check it out and see if it needs a rebuild.

 

Those ZF Tranny's sure are tough!(No pun intended lol)

Chopped off my tailpipe and glasspack and installed an 18" straight pipe, with a downpipe. Then, my dad got stuck in his little Escape; highcentered on some hard packed snow, so I went and got him. Had to back down the mountain side about a mile long, no way were either of us to turn around, so reverse it was.



Only pic I got, was when I got there, just about to strap up. Also, burnt my clutch a little, my wide tires aren't suited for the tiny ruts that were up there, so I kept veering off to the sides every now and then

 

Guess it's time to take the Escape emblems off that car.

 

on Saturday I drove it a couple hundred miles for a cummins meet in the center of the state.

and on Sunday I tightened the exhaust clamp on the S400 turbo as it had come loose, and I installed my back up camera finally. I can see from my rear bumper now!

 

Hauled a load of firewood with the Ram, did great for a 1500