What Did You Do To Your 2ND GEN RAM Today?
Just bought it earlier this week. Cleaned it up, oiled hinges, greased latches, replaced underhood work-light bulb and battery tie-down. Tomorrow it gets an oil change, oil and air filters and I try to figure out why the e-brake warning light is on....even though it seems to be fully released and the fluid level is full. Suspecting switch. Maybe flush the brake fluid and check rear shoes and front pads.
Just bought it earlier this week. Cleaned it up, oiled hinges, greased latches, replaced underhood work-light bulb and battery tie-down. Tomorrow it gets an oil change, oil and air filters and I try to figure out why the e-brake warning light is on....even though it seems to be fully released and the fluid level is full. Suspecting switch. Maybe flush the brake fluid and check rear shoes and front pads.

i just fired mine up...its 30 degrees it hasnt been started in about a week, and it fired up first crank lol...today im starting work on her...im tearing apart the front end when i get out of work.....i hate driving my fiancees maxima...i want to drivemy RAM again
.....but my RAM wont need anythin after im done this "Overhaulin" im doing...ive pretty much replacd everything else
.....but my RAM wont need anythin after im done this "Overhaulin" im doing...ive pretty much replacd everything else
Adjusted my steering box after about 6 months of talking about it. Followed the link and still have a small amount of play but that must be due to some other problem. Supposed to be 45 and sunny here in michigan... What else to do?
Also painted my drums black. All I had was 500 deg. Engine paint (gloss black) we'll see how it holds up. Better than rust for now.



