Gave her some new floormats, black rubber with the large Ram logo in the center in red.

 

Installed my White instrument guage overlays.They were pretty easy to install.Didn't have to remove the needles and you can wet them with a soap and water solution so you can adjust them if needed once you stick them on.The only thing I don't like about them is the film the goes over the areas where the light shines through is a little darker than I would like. But I plan on installing leds soon so that should brighten them up some.

 

Got the rest of my wiring stuff for my lights yesterday, only to find out I got the wrong fuses from wally wolds....

 

Just got back tonight from the Valley visiting grandkids for Christmas (spoiled the ROTTEN!) Did not take the Ram, but as it has been sitting in the driveway unattended for a week, decided to check to see if it would start......busted right off like it is supposed to! Couldn't be happier! (was afraid I would have to start a thread tomorrow someting like "Ram won't start.......")

 

Well I had started to measure my gas mileage today untill the wife decided to go get our son from day care in our truck. Now mind u its a 30-40 min drive with traffic. I don't know how she did it but she managed to use just over 1/8th of a tank in doing this. O well guess there's always next month to do it.

 

Put new tires on her yesterday.

 

Wired up my lights yesterday, then realized I needed another power wire to the switch. Oh well, that is what I have Thursday for.

 

Had a nasty growl under the hood this morning. The idler pulley went south. Replaced that and the tensioner pulley just cause it looked at me wrong.

 

lol...

I got my fog lamps too start working again!!!

 

Installed my sub.....