When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
GOT IT......F that. And yes I was using the 3/4 socket. HEAT HEAT HEAT, PB Blaster, repeat and finnaly they came loose.........Now a new delema, the outer axle shafts are rusted sold onto the hub assemblies (rust welding!)......TWO new outter shafts ordered up!
GOT IT......F that. And yes I was using the 3/4 socket. HEAT HEAT HEAT, PB Blaster, repeat and finnaly they came loose.........Now a new delema, the outer axle shafts are rusted sold onto the hub assemblies (rust welding!)......TWO new outter shafts ordered up!
Where did you get the new outer shafts? I just ruined one today, and there it sits in the shop till i get what i need for it. Whats going to be the best bet for the parts and where to get them? Ive already got the new greasable u-joints, front left hub assembly,(heat ruined it last time i tried to get it off).
I'm going to look for the Cyclo and Knocker loose next time i go to NAPA. I have been using WD-40 for years w/o any good results. Good protectant, though.
I'm going to look for the Cyclo and Knocker loose next time i go to NAPA. I have been using WD-40 for years w/o any good results. Good protectant, though.
WD-40 sucks. It is nothing more than Kerosene. It evaporates rather quickly, and when people use it as a lubricant it actually collects dirt and gums up the works.
I found some of the ends at zumbrota bearing and gear, their website is www.zbag.com They want 98 and some change for the end and new nut. Still not cheap. ****ty deal all around, now im just wondering if i should just get both of em, just in case the other ones **** too.