When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
My question is this
can you swap out a 46re for a 46rh wouldn't you just need to change the transmission control module and the wiring going to the transmission
thanks for your help
There isn't a separate trans control module on these trucks. It is all in the PCM. You could possibly get a custom tune, that left out the governor stuff..... but, that would run 4-500 bucks.... Easier/better/probably cheaper to just get the right trans to begin with.
There isn't a separate trans control module on these trucks. It is all in the PCM. You could possibly get a custom tune, that left out the governor stuff..... but, that would run 4-500 bucks.... Easier/better/probably cheaper to just get the right trans to begin with.
already have a trans thanks for the info about the pcm. Was thinking about putting a tune on it anyway's but a trans runs 600-1200 plus
There isn't a separate trans control module on these trucks. It is all in the PCM. You could possibly get a custom tune, that left out the governor stuff..... but, that would run 4-500 bucks.... Easier/better/probably cheaper to just get the right trans to begin with.
What about taking the PCM and computer from the donor truck? I have a complete 97 ram, doing research on dropping the 97 318 and 46 RE into a 95 that has the 318 and 46RH. I would think that if you took the wiring harness, pcm and computer, it should work without any added labor than the harness and parts swap.
What about taking the PCM and computer from the donor truck? I have a complete 97 ram, doing research on dropping the 97 318 and 46 RE into a 95 that has the 318 and 46RH. I would think that if you took the wiring harness, pcm and computer, it should work without any added labor than the harness and parts swap.
Don't we have a thread going about just this swap?