When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
ok, i have about had it with this truck and its issues since i bought it. 94 1500 4x4 and it has been swapped with a 96 360, 5 speed, and obd2 pcm. it is an auto pcm, but was running and driving fine before. as far as i can tell i have no injector pulse. tested with a noid light and got nothing. my question is, is my pcm bad? does anything else factor into the injectors getting power? thanks!
my fuel pressure is low 40's at the rail, crank sensor looked and ohm'd fine, but i tried a different one just to see and same thing. as far as the asd relay, i bought 2 extras before so i know they are good, cause i can swap with the starter relay, but no pulse at the injectors themselves
How are you checking the pulse? The common wire should be hot while cranking and the other wire will be the pulsing ground, checked by putting the "Ground" wire from the test light on a 12v source.
i do have spark, it will run as long as im spraying starting fluid down the t.b. and i know theres no pulse cause i checked the wires with a noid lite and it never once flashed
Check the ground wire up above the power steering pump. Just follow the injector harness forward from the manifold on the drivers side. Make sure that one is clean, and tight.
You need to verify fuel pressure obviously. I think your fuel pump simply took a dump.
Originally Posted by autolockguy13
i do have spark, it will run as long as im spraying starting fluid down the t.b. and i know theres no pulse cause i checked the wires with a noid lite and it never once flashed