I think the frame is box in parts but i wanted to do it this way plus my axles are all new with 4.56's plus this truck needed to be put down a long time ago. It was ruff!!!!

 

Well trying to figur out why my turn sign dose not work little recap this started after i swap dashs so something to do with that i am guessing.
-Left turn signals work fine
-Right rear turn signal works
-The little green arrow in dash dose not work for right turn
-The front right turn signal dose not work either
-It dose not matter if it the turn signal or 4 ways both do the same thing
-Have power coming out of flasher
-No power to the pin for the dash
-No power to the front right turn signal either

Any ideas????? kinda lost wish i had a good wiring dram for my truck

 

Check the ground wire for the right front turn signal. Should be a black wire.... not sure where it actually runs off to.

 

Well i been kinda of lazy and not posting my progress just cause i have not done much due to lack of money (i am a collage stundent). But i worked over the break and last weekend i sold my dana 60s and now have the cash to finsh my project i started. So my fly wheel and clutch is all order and well hopfully get the transfor case back together next week once i bring it to school so i can use the press and the pullers. The only thing i can think of that i still need to order or find is the shifter boot cover. The one in the other truck was falling apart. I tryed find them online anywere and cant find it so i think i am stuck buying from the dealer.

 

Try LMC Truck as well. Or a junkyard......

 

Well cant find a shifter boot dodge cant get them so i pretty much stuck making something but that well wait till i am do.

But any way back to the swap. My goal this weekend is pull my trans and have my new one bolted in. I have a new fly wheel with new fly wheel bolts and clutch. Only thing i dont have is bolts to bolt the clutch to the flywheel. Cant find part number anywere and not sure if i can use like a grade 8 bolt or not?

 

I lucked out and found a truck in a nearby yard that still had the floor console boots and all in it. I was also able to grab the dash pocket.

 

What is the name of the yard you go to?

 

I bet its mason dixion lol.

 

Highly doubt it. They haven't had a manual 2nd gen, let alone any new 2nd gens in the yard in the past 4-5 years.