When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
The leak is coming out of the tranfercase by the drive shaft does anyone know how to get that bearing out? The transfercase has 5 or 6 bolts holding on the housing can I pull that off?
i have a leak at my front driveshaft....and are you talking about pulling the transfer case? if so, its a pretty simple job...i changed my t-case in my driveway.
Its most likely to be the rear seal on the transfer like 97tn4x4 said. I had to do a couple of them and yeah they are not hard. Kinda seemed hard to find a little but the istall is not hard. You dont need to pull the transfer just knock the seal out and put the new one in.
Its most likely to be the rear seal on the transfer like 97tn4x4 said. I had to do a couple of them and yeah they are not hard. Kinda seemed hard to find a little but the istall is not hard. You dont need to pull the transfer just knock the seal out and put the new one in.
Ya its the rear seal on the transfercase! So if I take off the drive shaft the yoke will slide right out the transfercase? If so all need to do is pull the old and press the new one in?
Ya its the rear seal on the transfercase! So if I take off the drive shaft the yoke will slide right out the transfercase? If so all need to do is pull the old and press the new one in?