Oil leak Help!
#1
Oil leak Help!
so i just did the plenum fix on my truck and now it leaks oil. The oil is dripping off of the transmission pan and the belhousing where it bolts up to the motor. I'm thinking its leaking off the back of the plenum gasket and going down the back of the motor and transmission. I did put all new seals on when i did the repair. The only thing i didn't replace was the coolant bypass hose (and thats NOT leaking !)
Has anyone else expirienced this? any help would be great!
Has anyone else expirienced this? any help would be great!
#2
There are some little holes in the block, and '****' on the seal, that go into those holes. Helps hold the seal in place. If you didn't get the holes cleaned out good, the seal won't sit in place, and can push out, giving you a leak..... grab a mirror, and bright flashlight, and look around back there, see if you can find where it is coming from. Keep in mind, the oil pressure sensor is back there as well, and if that got tweaked, it can puke a boatload of oil pretty quickly.
#3
#5
Buy a new intake gasket set. You cannot reuse the intake/head gaskets, and the set will come with new end seals. You will also need new intake bolts, as it isn't recommended to re-use the torque to yield fellers.
#6
remove air filter and as much other clutter as possible, maybe dist cap.
spray the back of the block and intake with brake clean and get it as clean as possible.
cut any protruding rubber seal out of the way.
using a finger, or craft stick or putty knife, fill the intake gap/seal with high temp rtv. go all the way across the back.
allow about 24 hours for it to set. then put on another big fat coat, and smear it out in a wide pattern onto the block and intake. let dry.
try it and see if it works. if it does, you save redoing the whole thing. if it doesn't then all it cost was a couple of days and $10 worth of rtv.
#7
being lazy - i'd try this...
remove air filter and as much other clutter as possible, maybe dist cap.
spray the back of the block and intake with brake clean and get it as clean as possible.
cut any protruding rubber seal out of the way.
using a finger, or craft stick or putty knife, fill the intake gap/seal with high temp rtv. go all the way across the back.
allow about 24 hours for it to set. then put on another big fat coat, and smear it out in a wide pattern onto the block and intake. let dry.
try it and see if it works. if it does, you save redoing the whole thing. if it doesn't then all it cost was a couple of days and $10 worth of rtv.
remove air filter and as much other clutter as possible, maybe dist cap.
spray the back of the block and intake with brake clean and get it as clean as possible.
cut any protruding rubber seal out of the way.
using a finger, or craft stick or putty knife, fill the intake gap/seal with high temp rtv. go all the way across the back.
allow about 24 hours for it to set. then put on another big fat coat, and smear it out in a wide pattern onto the block and intake. let dry.
try it and see if it works. if it does, you save redoing the whole thing. if it doesn't then all it cost was a couple of days and $10 worth of rtv.
Now I am really glad that I took the time to really clean out those holes for the rear dowel gasket. Took about 15 mins with a 1/32 inch drill bit.
Trending Topics
#8
#10
Ain't that the way of things though? Personally, I think you learn more from making a mistake of this nature, than you do reading about someone else's trouble. I have made more than a couple boo-boos in my time........ fortunately, not many of them were hideously expensive.