Harland Sharp 1.7 RR's
Professional
Joined: Dec 2011
Posts: 111
Likes: 0
From: NC
Here, most of the way down the page. 1200 bucks.
http://www.precisionengine.com/rebui...nes/index.html
Champion
Joined: Jun 2004
Posts: 2,811
Likes: 2
From: Ft Campbell, KY/TN
Just looked at that ebay link, don't think those are right for our engine, don't buy them.
They look to be a Chevy set that you could put on the Edelbrock aluminum heads, but not the magnum heads.
The adjustable ones for stock heads are near $500, nobody world be selling them that cheaply.
They look to be a Chevy set that you could put on the Edelbrock aluminum heads, but not the magnum heads.
The adjustable ones for stock heads are near $500, nobody world be selling them that cheaply.
ANy roller rocker that goes on a 3/8 stud requires guideplates.....AND hardened pushrods. So, you will end up spending close to 500 after you buy those 289 dollar ones.
Record Breaker
Joined: Feb 2009
Posts: 1,133
Likes: 18
Professional
Joined: Dec 2011
Posts: 212
Likes: 0
Guess I need to invest in a spare motor, mines gettin ready to click 270,000 and still runs like a champ
Here, most of the way down the page. 1200 bucks.
For $1200 I don't give a rip if it's rebuilt!
That's impressive! Still wouldn't start throwin' hot rod parts (or any good money) at it if it were me.
Last edited by Wombat Ranger; Feb 21, 2012 at 09:41 PM.