On a 95 1500 with the 360 will I need a 8 pin or 12 pin od solenoid?

 

On a 95, there should only be three.......

 

Ok so this is confusing me...the parts stores keep asking if its an 8 or 12 pin...I thought what I need was an assembly that goes between the filter&valve body.Since that tcc code 37 Im still trying to cure.So Not exactly sure what to order now.

 

Should be a solenoid set. Two solenoids on a bracket, with some wiring. Power feed is common for both, two ground wires run off to the PCM. Check the connector on the side of your trans, drivers side, behind the shift linkage about a foot. Should be a connector there, and should be three wires..... the parts store is looking at the RE trans, you have an RH.

 

Ok heyyou.I Think Ive told you my problem more than anyone else.So what do you suggest...my comp test came out fine.What should I buy for this code 37 to see if it cures it?
Also heres a few pix theres one plug on the side&one on the top.The smaller on the top was wet when I pulled it.Also theres another connector Not plugged into anything.. I didnt have a factory tow package so no trans temp sensor

 

First pic is the park/neutral switch. (right under the linkage.) The connector for the solenoids should be right above, maybe slightly to the rear... of the rear cooler line. Can't really see it in the pic. If you have a two wire connector there that is indeed strange.

 

I see one plug in on top no idea should there be two plugs up there?Yeah no idea what that loose plug is for.

 

Should only be two electrical connectors that actually connect to something ON the trans..... Can you get a pic of the other one??

 

Yup Ill run out there in just a second

 

Heres the pic...only one. spot for a plug to go&thats where its plugged i to...the one Thats nots plugged into anything I belive was for if I had. a trans temp sensor.
Im about to go to the parts store..any idea what I should buy?The tcc od assembly or the actual solenoid..About to run out in just a sec