Motor swap?
#41
I am not sure what happened. Still new to photobucket, I checked my account and I must have messed something up during upload. Who knows lol I will def be putting up some pics. Getting it on friday or saturday, prepping to pull it all week, doing the swap next weekend then trying my best to get it all right putting it back together. Not putting a time line on having it running though hahaha def not counting my chickens before they hatch on this one!!!
#42
I am not sure what happened. Still new to photobucket, I checked my account and I must have messed something up during upload. Who knows lol I will def be putting up some pics. Getting it on friday or saturday, prepping to pull it all week, doing the swap next weekend then trying my best to get it all right putting it back together. Not putting a time line on having it running though hahaha def not counting my chickens before they hatch on this one!!!
Getting used to photobucket can be a little challenging. When the upgraded I was having connectivity isses, so went back to original version.
When loaded, click in the "IMG" and the text box beside it shoud rhange to "copied" for a moment. Then go to post, and right click to paste that link into body of post.
#43
I have another question I thought about. I am going to pick up this motor and tranny on friday. I did the hughes plenum fix a few months ago on my 5.2. Should I leave that on my motor and buy a new kit for this 5.9, seeing as my motor is still perfectly fine, and sell it that way? Or should I take it out and put it on the new motor? I kinda would rather just get a new one and put it on the 5.9, but I would like your guys opinion on it.
#45
#47
Update, got my motor ready to pull other than the motor mounts. I have to take my damn brush guard off too, ughhhh. Had some stuff come up and had to put off getting the till today. Finally got it. My luck, the transfer case is wrong. Atleast where the front drive shaft connects it is wrong, so I am assuming it is wrong all together, not for sure though. Motor is just what I am looking for, will have to use my wiring harness.
Last edited by woods4life; 03-03-2013 at 09:20 PM.
#48
Update, got my motor ready to pull other than the motor mounts. I have to take my damn brush guard off too, ughhhh. Had some stuff come up and had to put off getting the till today. Finally got it. My luck, the transfer case is wrong. Atleast where the front drive shaft connects it is wrong, so I am assuming it is wrong all together, not for sure though. Motor is just what I am looking for, will have to use my wiring harness.