When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
You are working on a 2001 not a 95 right ? The motor is down by the floor/tranny tunnel. Did you get some help and check like I described? You need to see if that motor is rotating and how much.
It's not the mechanism with a rod connected to it right behind the glovebox? If not, is it behind the plastic bulge held on with two screws on the tranny hump?
The motor for the blend door is the one by the tranny hump. One of the screws is quite hard to get to. But right now you just want to see if it (the motor) turns or if it's jammed.
The silver piece coming out of the center of the actuator I guess it is, does not turn on any setting. Would it be worth my whole to check and see if all lines are hooked up in the control panel for the A/C and heat? Heat blows out of every setting of fan speed/temp/and location.
In that case you might be lucky and don't have to take the HVAC box back out. Either the motor itself is bad, the control panel is bad or the wiring. Now all you have to do is figure out which one.
In that case you might be lucky and don't have to take the HVAC box back out. Either the motor itself is bad, the control panel is bad or the wiring. Now all you have to do is figure out which one.
04-18-2013, 02:44 PM
The motor is down by the floor/tranny tunnel. Did you get some help and check like I described? You need to see if that motor is rotating and how much.