since your a moderator as well, how do I go about to being able to post pictures in my album again, it said I'm unable to [ost pictures until I contact an admin...

 

To all, you guys finally found the page where to install the engine mounts thank you for the help!

 

My other question is do I need restriction pads for my motor mounts for my 1500? I searched them up and they sell for 2500 and 3500s so it has me thinking?

 

Apology accepted, Keaton. Thanks for being upstanding. It's a main reason I remain on this forum (me and the other five, ha).

Glad you've found some good info GageD1. I hope you can just jack up the trans but it may hit the body since it rides so close. Of course, I have the manual so it may be taller.

I've never heard of a "restriction pad." What does that do? Sounds like a personal hygiene product, lol.

 

Lol yea I keep searching and they come up with the 2500s and 3500s but I attached the pic from the manual and they're no.3 on the diagram..

 

When I did my tranny for some reason it wouldn't Jack up high enough until I disconnected the 4wd lever from the trans

 

Oh, those. I just re-used my old ones. They kinda just pealed off the OE mounts so I put them back on. New mounts didn't come with. If they sell them for 2500s, it's the same part for 1500s. The mounts used for the V8s are way overkill and I think they're the same on the cummins. Almost everything is interchangeable between the models in our generation.

 

So worse case scenario could I get them from AutoZone or napa? I attached an eBay kit of what I would assume would fit them

 

If you have the time here's the link to a ram transmission mount for a 2500 if that made a difference but I planned on doing similar like in this video

 

That should work as the 2500 and 1500 share the same frames and mounts