When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Ok, do all the trucks in 2000 have intermittent wipers? I have 3 speeds only, non of the intermittent controls on the stick does anything but run the 1st available speed. Anyone have a picture/location of what controls the intermittent portion? Because apparently with this truck, I have to verify the unit wasn't just ripped out with a vengeance ! (see my unresponsive vent thread for reference....)
Ok, do all the trucks in 2000 have intermittent wipers? I have 3 speeds only, non of the intermittent controls on the stick does anything but run the 1st available speed. Anyone have a picture/location of what controls the intermittent portion? Because apparently with this truck, I have to verify the unit wasn't just ripped out with a vengeance ! (see my unresponsive vent thread for reference....)
Yes they do. Mine didn't work so I pulled apart the switch and the contacts were corroded.
Got it, there are 3 versions and I probably want the easiest to identify (single harness model). I'll check to see if its sitting under my dash, or if there is plastic left behind under the mounting screws !
Switch just sends a signal to the CTM. CTM actually controls the wiper motor.
Yeah it's setup just like the earlier send gens but it's if the signal going straight to the wiper motor it goes to the CTM. I still vote contacts dirty in the switch :b
What contacts were corroded? I can check the spare that I confirmed did the same thing as the one installed. Rather not buy a 3rd swtich, and have 2 spares...
What contacts were corroded? I can check the spare that I confirmed did the same thing as the one installed. Rather not buy a 3rd swtich, and have 2 spares...
In the multifunctional switch. Take the torx screws off the back and you'll see all the contacts mine were corroded bad in all my trucks (96, 97, 99, and 01)