96 dodge ram 2500 v-10 4x4 AT w/ OD 214,000 original miles
#192
#194
I just had the oil pan off mine when I did my timing chain. comes out pretty easy if you remove flywheel inspection plate and swing the rear of the pan to the passenger side, then straight out.
I was looking around a while back and found an all aluminum duel fan radiator that Griffin makes if you wanna drop $1,300.
That $198 for t-stat housing sounds pretty good right now, I've seen them for a lot more than that.
Oh, you can pull the pan out right after you unbolt the pick-up tube of course. It's easy to get to.
I was looking around a while back and found an all aluminum duel fan radiator that Griffin makes if you wanna drop $1,300.
That $198 for t-stat housing sounds pretty good right now, I've seen them for a lot more than that.
Oh, you can pull the pan out right after you unbolt the pick-up tube of course. It's easy to get to.
Last edited by racefan41; 02-07-2020 at 09:32 PM.
#195
Ready for re-install
I'm about to put the heads back on. Should I roll the engine over to knock some rust off the cylinders first? Tried with the BFW! With the heads off you still can't turn this engine over?
On the head gaskets. Does the number go up? Like on the valve cover gaskets? There's blue and grey on one side and just all grey on the other.
DANG! These heads are a bit heavy!
On the head gaskets. Does the number go up? Like on the valve cover gaskets? There's blue and grey on one side and just all grey on the other.
DANG! These heads are a bit heavy!
#196
#197
Well, let's just say moral is at an all time low with this project! I tried to turn it over when the heads and plugs were on and it was no go! Just like now.
Turn it over to the right?
Without head testing facilities on this island. I'm not holding my breath this works! However, $225 for gaskets is cheaper then a new truck! If the engine is fried. It will be time to grease the chain on the MTN bike and suck it up for a while!
Turn it over to the right?
Without head testing facilities on this island. I'm not holding my breath this works! However, $225 for gaskets is cheaper then a new truck! If the engine is fried. It will be time to grease the chain on the MTN bike and suck it up for a while!
#199