When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Yes, I replaced the electronics as well. I’m gonna put the old wiring harness and hopefully that’ll be the issue.
i think I found the Issue.
I have a 1997 ECM instead of the original 1996 ECM. Will that be the determining factor?
Last edited by Juan Sauceda; 08-17-2019 at 05:34 PM.
96 and 97 should be pretty much the same thing. I don't *think* any of the pinouts changed..... but, I haven't looked at every single one of them either..... Pinout on the trans connector did not change though. (but, wire colors may have.....)
Fix the first one, it will take care of the second one. Pressure sensor is only supposed to get 5 volts, my guess is, it's getting 12. Got a short somewhere.