Where did you mount your amp
#11
#14
RE: Where did you mount your amp
i didnt pull my carpet to run my wires....i just cut a slit in the carpet where i need the wires to come to cut a slit(if needed) from where they were running from and i tightly tape one wire at a time to a straightened out metal coat hanger and pushed it to the other hole and pull them through one by one just like that.....wasnt hard at all.
under the backseat would be fine as long as there is air flow and/or 3 inches of space on each side of the amp
Steve-o
So would under the backseat be a bad idea?
Steve-o
#15
RE: Where did you mount your amp
i mounted mine on the rear cab wall, drivers side. predrilled the holes and siliconed them when placing the screws.
the wiring is underneath the plastic piece at the doors., across and then under into the firewall/and up to the stereo.
pics in my gallery for reference.
the wiring is underneath the plastic piece at the doors., across and then under into the firewall/and up to the stereo.
pics in my gallery for reference.
#18
#20
RE: Where did you mount your amp
My '95 was set up with 2 tens and the amp under the backseat. I had another amp to push the 6x9s in the doors mounted behinde the back seat on the cab wall... be sure to seal your screws with silicone.
The seat comes out with the 4 bolts, use a lifting motion to lift the back part off of "hooks" that anchor it to the cab wall.
The seat comes out with the 4 bolts, use a lifting motion to lift the back part off of "hooks" that anchor it to the cab wall.