Double Din Head Unit ?
#1
Double Din Head Unit ?
Was looking at this unit and wondering if it would fit?
http://www.clarion.com/us/en/product...409024110.html
and the face plate do they make one to fit doubles?
http://www.clarion.com/us/en/product...409024110.html
and the face plate do they make one to fit doubles?
#4
Join Date: Mar 2007
Location: Turn down the heat please
Posts: 11,333
Likes: 0
Received 1 Like
on
1 Post
You will have to cut the bezel, I'm nearly positive it will fit fine back there width wise, may want to look back there and measure for height though. My MyGig is actually a little wider than the 'ears' on the stock radio and it fits in like a glove, I think it's slightly shorter than a double din, might be the same I'm not 100% sure.
#6
Guest
Posts: n/a
the MyGig is not a standard double din... it is wider and shorter. (atleast the face is from the measurements I pulled from a 300 on the lot) A double din should in theory use the same mounting points as the factory radio, since the aftermarket dash kits do. and you would be cutting, so you could measure it out so that they would...
You will still need to find a way to fill the "ears" left by the volume *****, since a double din radio isnt any wider than a single din radio...
a dremel with a cutoff wheel will do the job just fine.
You will still need to find a way to fill the "ears" left by the volume *****, since a double din radio isnt any wider than a single din radio...
a dremel with a cutoff wheel will do the job just fine.
#7
Join Date: Mar 2007
Location: Turn down the heat please
Posts: 11,333
Likes: 0
Received 1 Like
on
1 Post
the MyGig is not a standard double din... it is wider and shorter. (atleast the face is from the measurements I pulled from a 300 on the lot) A double din should in theory use the same mounting points as the factory radio, since the aftermarket dash kits do. and you would be cutting, so you could measure it out so that they would...
Trending Topics
#8
I don't believe they make a bigger dash bezel than single din for our trucks do they? or is there a nav one thats a little bigger, I don't mind cutting mine as long as it's perfect cuz thats the way I like things. I'd take my time. did you have to Paint the Dash Bezel after cutting it? or was it pretty clean after cutting it?
#9
Join Date: Mar 2007
Location: Turn down the heat please
Posts: 11,333
Likes: 0
Received 1 Like
on
1 Post
Well mine isn't cut perfect thanks to a few slips but for now it's installed as is. I had no time to deal with it when I installed the MyGig. When I have more time and a place to paint I'm going to fix up the edges of the cut then sand the whole thing down and paint it, you can't really tell unless you look close but it bugs me and I also hate the fake wood.
#10