View Poll Results: Headers
Kooks
6
3.77%
Borla
9
5.66%
Dynaflow
0
0%
Edelbrock
10
6.29%
Pacesetter
44
27.67%
Hooker
7
4.40%
JBA
29
18.24%
Headman
6
3.77%
Dynomax
3
1.89%
Gibson
17
10.69%
Doug Thorley
3
1.89%
OTHER (please specify in a post)
25
15.72%
Voters: 159. You may not vote on this poll
Registered User
Can I fit Pacesetter Long Tubes on my '04 1500 4.7 Quad Cab 4WD? I know I will have to move the cats, and I live in a state with no emissions-type inspections. The only reason I ask is because I see on websites the only option available is for the Hemi of that year's models. If I select this option, will the headers fit?
Registered User
Word.
Veteran
Quote:
I had been use to more quieter setups (prior was Y pipe to 3" si/so Dynomax Superturbo w/ full carpet interior) so this current setup is a LOT louder than i thought it was. In addition the 3400 stall does not help in keeping the exhaust tone down when leaving from idle.
How are you liking your Mag' X setup?
I have a 3" Magnaflow X sitting in the garage that i am going to have put in just for a change if it will help in lowering the noise level. Think the case length is a little longer but have to check the specs again.
Originally Posted by SLT8
There is resonance with the Dynomax under load but i removed my carpet for ST vinyl floor so that my be a contribution. I had been use to more quieter setups (prior was Y pipe to 3" si/so Dynomax Superturbo w/ full carpet interior) so this current setup is a LOT louder than i thought it was. In addition the 3400 stall does not help in keeping the exhaust tone down when leaving from idle.
How are you liking your Mag' X setup?
I have a 3" Magnaflow X sitting in the garage that i am going to have put in just for a change if it will help in lowering the noise level. Think the case length is a little longer but have to check the specs again.
My Mag x pipe muffler has a great sound. Drones some under a load, but sounds so sweet I don't care. I also had an original sido super turbo, on my truck . Now there's a quiet setup, in and outside of the truck
Veteran
Quote:
Originally Posted by Old Man with a hemi
Nice set-up. I've run the magnaflow x muffler, how is the noise level on the dynomax ultra-flow. Do you get much resonance in the interior?
For the person who was wondering about an x flowmaster muffler, since flowmasters are chambered, I see no way fo them to make an x pipe muffler, without deviating from their chambered design to a more straight thru design
Rookie
How much did you pay for the coating?
Amateur
What kind of supercharger are you running and what kind of cash/time did it take you?
