Thanks Weed and OlDirtyJohn,
Couldnt have done it with out your knowledge and help.

I want to do some more testing to see if you can run the 2.2kohm and the 390ohm at the same time, without any issues.

 

Would a hair dryer provide sufficient heat to shrink heat shrink tubing for the wires?

 

A hair dryer may .... depending on how hot it really gets. You can just use a lighter; keep the flame away from the tubing so you dont burn it, and just use the heat. Always keep it moving until it shrinks no more, and then stop.

 

I use the flame from the lighter on mine but just keep it moving. So either way it can be done.

 

keep us updated i may try to run the 390 resistor on line 2 with my 2.2 already and see what ahppens

 

Im new here but i have been trying to decide if i wanted to give this a shot so today i made the plug to run the 2.2k ohm resistor on line 1 and 3 and noticed a slight difference just driving around so then i went ahead and added 350 ohms or resistance on line 2 at wot it shifts 2nd to 3rd at about 5600 rpms i was impessed at the differnce tomorrow i am goin to bump it up to 390 ohms i will post back up if there is a difference.

 

Make sure you reset your PCM for the best results.

 

I am planning on doing this on my truck and was looking for the one I can buy I would make one if I could find a place to buy the factory plugs because I dont want to cut the factory harness. Dose anyone know If you can buy them or not, also i have a 07 1500 5.7 hemi witch one would i use

 

any before and after speedo runs?

 

http://www.sonnax.com/product-lines/...ion/parts/1785