3rd Gen Ram Tech 2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

need help by morning! 06 died, turns over, wont start now

Old Nov 15, 2017 | 11:37 PM
  #1  
Sh40674's Avatar
Sh40674
Thread Starter
|
Registered User
Joined: May 2013
Posts: 16
Likes: 0
Default need help by morning! 06 died, turns over, wont start now

OK so me and the wife did some christmas shopping tonight, came back out, loaded the truck up, she put the baby in the carseat so i started the truck to keep him warm. walked around to the other side, started loading stuff and i could hear the exhaust idling real low, starting to putt like it was running out of gas. walked around to the drivers door to check the RPMs and it died before i got there. now it turns over just fine like normal, but no start and no attempt to start. kinda like it ran bone dry on gas. headed back out there (stuck at walmart, of all places) before work tonight and tried to scan for codes but nothing came up.. doesn't mean i don't have one, maybe it just wouldn't read? anyways, did that and then tried unhooking the battery for a couple mins, no dice. so i looked for the fuel relay and realized there isn't one, and read online it's incorporated into the whole fuse box? is that correct? called a TIPM? i do not hear the buzzing of the fuel pump when i first turn the key over if that helps any

so my questions here is what do you think fellas? bad fuel pump? the TIPM thingy? crank sensor? how do i test for each? never tested power to a fuel pump before. do you think it's something else?

i'm in a pickle, getting a vasectomy tomorrow so i wont be in any shape to work on my truck for a few days... and immediate advice or ideas would be greatly appreciated! i need my truck back on the road ASAP
 
Reply
Old Nov 16, 2017 | 12:14 AM
  #2  
Sh40674's Avatar
Sh40674
Thread Starter
|
Registered User
Joined: May 2013
Posts: 16
Likes: 0
Default

i should add it's a 4.7, 4x4. fuel is just below 1/8 tank. fuel gauge works fine as far as i know.
 
Reply
Old Nov 16, 2017 | 10:55 AM
  #3  
66three83's Avatar
66three83
Captain
Joined: Mar 2010
Posts: 725
Likes: 14
Default

No fuel pump buzz when ignition first turned? That’s a fuel pump failure. Try tapping your tank with a 2x4 or something while the ignition is on. Sometimes that gets it going again, but replace immediately!
 
Reply
Old Nov 16, 2017 | 11:03 AM
  #4  
TNtech's Avatar
TNtech
Site Moderator-Dodge Tech
Joined: Sep 2010
Posts: 3,724
Likes: 22
From: Nashville, Tennessee
Default

I'm thinking fuel pump as well.

Originally Posted by Sh40674

i'm in a pickle, getting a vasectomy tomorrow so i wont be in any shape to work on my truck for a few days... and immediate advice or ideas would be greatly appreciated! i need my truck back on the road ASAP
Hey but there's good news! You can get a new truck in about 18 more years LOL

Two Words: Frozen Peas.
 
Reply
Old Nov 17, 2017 | 09:26 AM
  #5  
Sh40674's Avatar
Sh40674
Thread Starter
|
Registered User
Joined: May 2013
Posts: 16
Likes: 0
Default

Got the frozen peas on right now! Lol.. shot some ether in the intake and it fired, so ots 100 percent a fuel delivery problem... what are the chances of this being the TIPM not giving power? Hit the tank with a mallet and it didn't help.
I'm having a buddy fixit for me while I'm down, just want to make sure it's 100 percent the fuel pump before I have him rip into it
 
Reply
Old Nov 17, 2017 | 11:12 AM
  #6  
HeyYou's Avatar
HeyYou
Administrator
Veteran: Air Force
Community Favorite
15 Year Member
Community Builder
Joined: Apr 2010
Posts: 87,480
Likes: 4,223
From: Clayton MI
Default

Verify the pump is getting power, but, you aren't getting fuel pressure.
 
Reply
Old Nov 17, 2017 | 08:04 PM
  #7  
redangel's Avatar
redangel
Registered User
Joined: Nov 2017
Posts: 2
Likes: 0
Default this happen to me once

Easy way to see if you have fuel pressure take black cap Off of fuel rail and press the Schrader valve down if fuel squirts out you know the fuel pumps working next push accelerator pedal all the way to the floor and try starting it sometimes throttle becomes sticky and the little motor that runs the butterfly get stuck computer has an override just like a regular cable driven carburetor
 

Last edited by redangel; Nov 17, 2017 at 08:18 PM.
Reply
Old Nov 18, 2017 | 09:05 AM
  #8  
Sh40674's Avatar
Sh40674
Thread Starter
|
Registered User
Joined: May 2013
Posts: 16
Likes: 0
Default

It was the fuel pump, thanks everyone!
 
Reply
Old Nov 18, 2017 | 01:18 PM
  #9  
66three83's Avatar
66three83
Captain
Joined: Mar 2010
Posts: 725
Likes: 14
Default

You’re Welcome!
 
Reply
Old Nov 19, 2017 | 01:04 AM
  #10  
redangel's Avatar
redangel
Registered User
Joined: Nov 2017
Posts: 2
Likes: 0
Default No problem

No problem
 
Reply


Thread Tools
Search this Thread

All times are GMT -4. The time now is 01:47 AM.