dude i've taken the door panels off MANY vehicles and NEVER had them come off as easy as the rams. its amazing honestly. heres how:

The fronts: remove phillips screw in triangle section covering mirror bolts, remove phillips screw behind door handle, remove both phillips screws at bottom of door, remove torx screw holding the handle to the lever mechanism. thats only 5 bolts total!! lift the panel and it just pops right off peice of cake. it takes literally 2 minutes if you dont have a clue what you're doing...30 seconds if you do.

the back is even easier. Only 2 bolts. the phillips behind the handle, and the torx inside the handle. lift and remove door panel.

so easy a caveman could do it...

 

AF--you done yet?!? ha I keep reading this thread hoping to see a finished product...WHERE IS IT?! Looks great so far

 

I WISH!!! i've run into a few non-truck related problems. I've got 3 papers totaling 18 pages due wednesday for my masters class that i havent started on cause i've been so focused on this build. As soon as it gets done, i'll be postin you can count on that. Thanks for watchin!

 

How much fiberglass mat did you use? I would like to do this fiberglass box also. I bought a cheap prefab and im not happy with it. Not enough air space. I have never messed with fiberglass, so im learning from you. Keep up the good work!

 

you'll need about 12 sq ft per layer. you should do at least 4-5 layers, so roughly 50-60 sq ft. you'll also need 2-3 gallons of resin

 

How did the papers go?

Now get back to work on the truck

 

anymore update?

 

no kidding AF- are you in a deep depression after getting your grades on your papers??

 

lol he updates on another site lol must have forgotten about this one lol

 

Boooo!!! I was so in to this. I hope he comes back to update.