Hi my 95 caravan 3.3 stopped ,dead in the water, while driving home. when we checked it was not getting spark. I checked the repair manual and elected to change the coil pack. Still no spark. so I changed the crankshaft postion sensor today still no spark. checked the fuses found and replace a blown fuse. still no start or spark. Im at my wits end can somebody Please help me Im just a poor cripple whose is trying to fix my only vehicle. any help would be appreciated.

 

Remove the washer bottle, I know you think I'm nuts. But next to the washer bottle and the hinge you will fine some fuseable links. remove the tie strap and check each wire with a slight pull. You may find a blowen fuseable link.

 

ok well i checked the wiring as suggested and first of all did not find any fusible links and I un taped just about the whole harness, and retaped. so I changed the cam shaft sensor wel still no luck. if anymore suggestions I would appreciate them. thanks

 

The fuseable links are not taped up. It would tie straps holding them together. It on the driver side just below the hinge.

 

ok will look again didnt see any before update coming

 

ok removed windshield washer res and checked still no fusible links, so I removed the relay box thats next to the ecm/pcm and all there is us a fat harness which connects via bolt to a plug on the firewall and a smaller one that splits off of it over to the passenger side of the van

 

there are fuseable links near the firewall right by the master cylinder!!!!

I find a common failure is major corrosion in the bulk head connector. caused by washer fluid dripping onto the connector. Washer fluid is corrosive!!!

 

ok im not say anything bad here but this is the 4th time I have taken the water bottle of and everything on that side Im sorry but there is no fusiblelinks on near or even close to where yall have told me the only thing there is is the harness and and it bolts to a plug on the firewall. so I am now at the point I have ordereda ecm /pcm and in hopes this will fix the situation. thanks for your helps so far.

 

well dfoesnt this just figure!!!!no fusible links put new ecm/pcm and shazam no f'in spark I think its time for a stick of Dynomite

 

I have a 1995 and found my fuse links in the wire harness loom next to the diagnostic connector. I'm sure the links are not your problem but that's where they are on your van. did you ever verify you are getting power to the coil or pcm or asd relay or fuel pump?