My wife's 2005 Sprinter went into limp mode (2 & R only) and is showing a p0715 code (Input/Turbine speed sensor A Circuit malfunction). Since the speed sensor appears to be on a control block on top of the valve body, I'm trying to make sure It's truly a bad sensor before I go through the effort of opening up the transmission to replace it. Oh yea, that and the $200 in parts and $170 in fluid.
Has anyone completed this project themselves that could share some experiences, or have any recommendation on how to verify that the speed sensor(s) are actually at fault, and not just a wiring connector for example?
I'd appreciate it.

 

Yes i have replace them on the dodge charger with the same transmission. And it did fix the problem. But you could also have a wiring problem too. If you need the pdf file for testing, let me know.

 

Thanks for the offer, that would be very helpful!

 

Send me your email addres or post it.

 

`hello i have a 2005 sprinter with code po715 i have changed electric control module two sensers1-05189057aa_1-52108314aa and still have same code after clearing ....any ideas

 

Welcome to DF
Do you need the a pdf file?

 

will you send me the pdf file?
Thank

 

Sure I can, Send me your email address by a pm and I'll send it.

 

master tech, i sent you a pm with my email can i get it to. mine also did the 730 code after it spit the 715 out. thanks for the help.

 

Yes code P0715 need PDF to check wireing Replaced conductor plate. Still code and in limp mode.

Once changed right part will unit clear limp mode or will I need to take to dealer?