Cuztom Installz & Hi-Fi Audio club
#1
Cuztom Installz & Hi-Fi Audio club
This thread is reserved for Audio Fanatics only. Meaning that you must have nothing factory in your vehicle for stereo components. NOTHING! Can't have stock radio or speakers. If you've done a custom build with stock equipment, (like Mygig install or installing Infinity sound in a non-Infinty vehicle...etc) then that is okay. I reserve the right to call out bogus installs! You MUST have a link to your pics!!! End of story. No stories why you don't have pics. People like pics. Pics.Pics.Pics!!! Please keep your posts reserved for joining or showing off your stuff. Please no questions about one anothers equipment. If you have any questions please use the PM services and it will keep the clutter down. Thank You
Here's My set-up and it's changing by the weeks.
Pioneer Avic-f90bt Navigation
Boston Acoustic Pro 6.5" components
RF old school 6.5" minisubs in the rear doors
10" Infinity Kappa Perfects mounted in custom built enclosure and protected by my custom design grills.
JL Audio 450/4 for the highs/minisubs
JBL/Crown BPX1100.1 for the subs.
Edead Ultra 80mil Damplifier on inside of doors. 2 layers on the backside of the painted panel and one layer just behind the door panel as seen in the pics. Damplifier has also been applied to the back wall(2 layers) and on the roof.(1 layer) I showed a pic of how thick the edead is....I measured it at 83mils with the platic adhseive cover.
Here's My set-up and it's changing by the weeks.
Pioneer Avic-f90bt Navigation
Boston Acoustic Pro 6.5" components
RF old school 6.5" minisubs in the rear doors
10" Infinity Kappa Perfects mounted in custom built enclosure and protected by my custom design grills.
JL Audio 450/4 for the highs/minisubs
JBL/Crown BPX1100.1 for the subs.
Edead Ultra 80mil Damplifier on inside of doors. 2 layers on the backside of the painted panel and one layer just behind the door panel as seen in the pics. Damplifier has also been applied to the back wall(2 layers) and on the roof.(1 layer) I showed a pic of how thick the edead is....I measured it at 83mils with the platic adhseive cover.
Last edited by dirtydog; 01-23-2010 at 11:46 AM.
#2
#3
can i join ;
Pioneer avic-x910bt
MB quart speakers in roof and in doors
Kicker L7 15" custom box:
JBL 640 watt for door speakers;
JL 300/4 for roof speakers
Hi-fonics brutis 1600 wat for sub and power acoustik bass processor
Kinetic HC800 for sub amp and jl amp also 0 guage ran though truck for power and 8 guage wire for sub.
front of the brutis 8 guage speaker wire for the sub
my setup!
Pioneer avic-x910bt
MB quart speakers in roof and in doors
Kicker L7 15" custom box:
JBL 640 watt for door speakers;
JL 300/4 for roof speakers
Hi-fonics brutis 1600 wat for sub and power acoustik bass processor
Kinetic HC800 for sub amp and jl amp also 0 guage ran though truck for power and 8 guage wire for sub.
front of the brutis 8 guage speaker wire for the sub
my setup!
Last edited by Jarrod904; 07-23-2009 at 03:25 PM.
#4
Most of my pics are in my sig.
HU: Pioneer DHP-5800
Door Speakers: 6X9 Infinity Kappa Perfects
Wall Speakers: 6 1/2" Infinity Kappa
Under seat mounted speakers: 6X9 Infinity Kappa Perfects
Amp for Speakers: 800W Eclipse 4 Channel
Woofers: Eclipse 10" 500W peak.
Amp for woofers: 1000W Kenwood Class D 2 Channel.
As of right now, the 6x9's that are under my seats are hooked up via the Eclipse amp, and the wall speakers are running on the HU's amp until I can get another 2 channel amp installed.
HU: Pioneer DHP-5800
Door Speakers: 6X9 Infinity Kappa Perfects
Wall Speakers: 6 1/2" Infinity Kappa
Under seat mounted speakers: 6X9 Infinity Kappa Perfects
Amp for Speakers: 800W Eclipse 4 Channel
Woofers: Eclipse 10" 500W peak.
Amp for woofers: 1000W Kenwood Class D 2 Channel.
As of right now, the 6x9's that are under my seats are hooked up via the Eclipse amp, and the wall speakers are running on the HU's amp until I can get another 2 channel amp installed.
#5
Guest
Posts: n/a
Hey guys!
Headunit: Alpine 9856 with full speed ipod cable.
Speakers: Alpine Type R Components (front) Alpine Type R coaxials (rear)
Subwoofer: Alpine Type S 10 inch
Amplifiers: T.M.A. 4 channel (75x4) MTX thunder 250
Line Driver: Phoenix Gold 8 volt
Capacitor: 2 farad stinger
Wire: 4 guage power and ground split from the cap to 8 guage. Stinger 12 guage speaker wire.
RCA's: Monster Cable XLN
I will snag some pics of the components and try to pull teh seats to snag a pic of the amps...
These amps are a temporary thing until my zapco 5 channel is repaired.
Headunit: Alpine 9856 with full speed ipod cable.
Speakers: Alpine Type R Components (front) Alpine Type R coaxials (rear)
Subwoofer: Alpine Type S 10 inch
Amplifiers: T.M.A. 4 channel (75x4) MTX thunder 250
Line Driver: Phoenix Gold 8 volt
Capacitor: 2 farad stinger
Wire: 4 guage power and ground split from the cap to 8 guage. Stinger 12 guage speaker wire.
RCA's: Monster Cable XLN
I will snag some pics of the components and try to pull teh seats to snag a pic of the amps...
These amps are a temporary thing until my zapco 5 channel is repaired.
#6
all my stock stuff broke... well except for the stock radio, i just tore that out due to no cd player.
Pioneer Premere headunit
(2) 13kv.2 Subs from elemental designs
(1) nine.2x amp from ED
(4) JVC dual speakers... from walmart as a quick fix.
heres pics so far...
in this you can see one of the quick fix speakers
the subs and amp...
and heres a video of the subs... older video and the truck doesn't look like that anymore lol
Pioneer Premere headunit
(2) 13kv.2 Subs from elemental designs
(1) nine.2x amp from ED
(4) JVC dual speakers... from walmart as a quick fix.
heres pics so far...
in this you can see one of the quick fix speakers
the subs and amp...
and heres a video of the subs... older video and the truck doesn't look like that anymore lol
#7
Trending Topics
#8
No pics because I'm digital camera illiterate when it comes to getting them on here, but i will post when i can get them. Headunit is an alpine CDA-9886 w/full speed ipod connection, replaced front door speakers with Infinity Kappa 692.9i's and rear door speakers with Alpine type R components (not sure of the model). Powering them with an Alpine MPR-F300 300 watt amp for now (not enough power for either). Looking for some ideas on a custom sub box under the back seat. I'd like to build my own and stick a 10" or 12" solo barickin it.
#9
hey guys here what runnin in my truck its just a small setup to get me by for now will keep changin stuff as i see fit....
kenwood-kdcmp925
kenwood kac-8103d 1000w max 300 rms@4ohms 500rms @2 ohms
kicker comp 10" in mdf box
i also have in front doors 6x9 jvc 3 way and infinity referance 6.5" in rear doors ....next is a amp for all door speakers and then new subs....stay tuned
kenwood-kdcmp925
kenwood kac-8103d 1000w max 300 rms@4ohms 500rms @2 ohms
kicker comp 10" in mdf box
i also have in front doors 6x9 jvc 3 way and infinity referance 6.5" in rear doors ....next is a amp for all door speakers and then new subs....stay tuned