What Did You Do To Your 2ND GEN RAM Today?
Open the lid of the console and that console thingy fits over the front edge.When you close the console it locks it in place. Even with the lid open it doesn't move.
http://www.ebay.com/itm/94-95-96-97-DODGE-RAM-CENTER-CONSOLE-ADD-ON-CUP-HOLDER-GS-10150-/350975906746?pt=Motors_Car_Truck_Parts_Accessories&hash=item51b7cb53ba&vxp=mtr
http://www.ebay.com/itm/94-95-96-97-DODGE-RAM-CENTER-CONSOLE-ADD-ON-CUP-HOLDER-GS-10150-/350975906746?pt=Motors_Car_Truck_Parts_Accessories&hash=item51b7cb53ba&vxp=mtr
Join Date: Mar 2011
Location: Fredericksburg, Virginia
Posts: 8,914
Likes: 0
Received 2 Likes
on
2 Posts
Ah gotcha. Interesting little contraption there.
you could always be extra cheap and get the cup holders that hang off of your door panel.
I use one of these in my S10:
much cheaper and it will heat/cool drinks or takeout food inside it too
My S10 didn't come with an armrest/center console and the seat is just a basic bench seat, so I put that in the middle seat and seatbelted it in so it doesn't move. Nobody can sit there anyway being a compact truck with a manual trans...
you could always be extra cheap and get the cup holders that hang off of your door panel.
I use one of these in my S10:
much cheaper and it will heat/cool drinks or takeout food inside it too
My S10 didn't come with an armrest/center console and the seat is just a basic bench seat, so I put that in the middle seat and seatbelted it in so it doesn't move. Nobody can sit there anyway being a compact truck with a manual trans...
As promised, here is my short write up on what i did for my cup holder.
This is the front portion of the holder. Notice how theres a plastic cover that is popped up some. Pop that up and underneath theres going to be a small hole just big enough for weed wacker string to fit through.
Same process applies for the rear and the other side of the holder. This is the rear.
And thats all there is to it. Like I said, its not professional by any means but it works good. This is the finished product in the dash.
This is the front portion of the holder. Notice how theres a plastic cover that is popped up some. Pop that up and underneath theres going to be a small hole just big enough for weed wacker string to fit through.
Same process applies for the rear and the other side of the holder. This is the rear.
And thats all there is to it. Like I said, its not professional by any means but it works good. This is the finished product in the dash.