What Did You Do To Your 2ND GEN RAM Today?
This morning I started putting bits back on my freshly painted ride.
Gas tank filter neck, rear wheel well liners, bed tie-down rails, tailgate buffers and bushes, spare tyre (tire) winch handle bushing, headlight/hood seal, and I was going to put the (new) fog lights back on... but the connector are different on this set than the previous (both Spyder).
Since I’m out of the size shrink tube I need, I put that off... I have some drinking to do this afternoon...
Gas tank filter neck, rear wheel well liners, bed tie-down rails, tailgate buffers and bushes, spare tyre (tire) winch handle bushing, headlight/hood seal, and I was going to put the (new) fog lights back on... but the connector are different on this set than the previous (both Spyder).
Since I’m out of the size shrink tube I need, I put that off... I have some drinking to do this afternoon...
Put the gas cap cover on...
the new taillights on...
the number plate mount, plate, and lights...
I planned out the spacers and screws needed to secure the hood vents...
will machine up the spacers tomorrow...
Tomorrow I’ll mount the ground effects package pieces to the bottom of the box...
The only other thing to do will be order new badges.
Tonight, maybe.
It’s almost done.
the new taillights on...
the number plate mount, plate, and lights...
I planned out the spacers and screws needed to secure the hood vents...
will machine up the spacers tomorrow...
Tomorrow I’ll mount the ground effects package pieces to the bottom of the box...
The only other thing to do will be order new badges.
Tonight, maybe.
It’s almost done.