New Brake Lines, Drag link and Front Hub Bearing Assemblies. Front end parts are going bad By the day!!!!

 

I had a good day. I swapped out non power/heated tow mirrors for power/heated. Installed the 'rock solid' steering fix which went a lot easier than I thought it would. Fixed the tow wiring in the bed for 5th wheel trailers. Sometime in the past a PO butchered in a harness at the rear and left a lot of bad wiring behind. Changed oil and filter, detailed interior and conditioned the leather seats.

 

Took it out for my first mud run with the lift and tires. Now I need to find a bigger mud hole

 

Put in new Tie-rods and steering dampener. One project down, many to go...

 

Put in my shock boots finally had to wait a month for them to come in now Im not gonna be to worried about going through some mud

 

Finished painting my Altezzas and reinstalled them.

 

Haven't done much to mine. Sunday I picked up a new fuse holder for my horns. It's a thicker wire so hopefully it solves the getting hot issue. I also bought a small pipe wrench to tighten all my fittings. I got the one side "done" and started working on the other and to my surprise the damn threads stripped out of the tank. I'm either gonna try a truck junk yard or order a new tank off ebay. One problem after another

 

Finally got my 14x3 on with breather and got some new valve stem caps.

 

Gave the truck its annual bath.

 

Trans check valve delete. Don't want that baby going again anytime soon.