What Did You Do To Your 2ND GEN RAM Today?
#5682
07-07-2011, 09:21 PM
Record Breaker
#5683
07-08-2011, 09:26 AM
Banned Goober Smoocher
This is a mock up pic...I have tested it in the truck and while it may lean to the left for some because you can't open the ashtray in 4 lo ( I could bend it away but I don't smoke) I prefer it right where I can reach it without leaning over.
I also had to move the boot trim back about a half inch.
I'll have it done this weekend... will post a finished pic.
I also had to move the boot trim back about a half inch.
I'll have it done this weekend... will post a finished pic.
Nice tires.
But really, fix your bumper. Get some sheet metal screws and a drill and screw that plastic piece back on. Seriously.
Sweet. I've never liked how I have to bend down to shift either. Nice work.
#5684
07-08-2011, 09:35 AM
#5685
07-08-2011, 09:39 AM
Banned Goober Smoocher
#5687
07-08-2011, 09:45 AM
Banned Goober Smoocher
#5688
07-08-2011, 02:33 PM
Champion
#5689
07-09-2011, 10:42 PM
Record Breaker
Changed the plugs, cap, rotor, and wires today. Got purty Taylors on there now.
Took off the TB and cleaned it and the IAS plunger.
Cleaned and painted several brackets and will bolt most of it back together tomorrow.
Debating on replacing the MAP sensor. This one works ok but would a new one work better?
Took off the TB and cleaned it and the IAS plunger.
Cleaned and painted several brackets and will bolt most of it back together tomorrow.
Debating on replacing the MAP sensor. This one works ok but would a new one work better?
#5690
07-10-2011, 12:38 AM
Registered User
Join Date: Feb 2010
Location: Killeen TX
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts