When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
i just replaced the head gaskets on my dads 95 ram 1500 5.2l, and the truck seems to run just fine but there is a coolant leak, not a big one, and i just cannot find where it is coming from. any ideas? thanks ahead of time.
Was it leaking coolant before you did the head gaskets? If not then maybe you bent the head gasket when installing it. I know I just discovered one of my freeze plugs is leaking so that is another option to look at.
If it is coming from down low as in below the head mounting surface then I would guess that either a freeze plug is leaking(more likely) or you have a cracked block(very unlikely).
EDIT: Your intake could be leaking at the back of it and letting coolant leak down the back of the block. Try looking with a falshlight with it running and look up at the back of the engine where the tranny mounts to the engine.
Yeah, you're going to have to see how high the leak is coming from. Because if it ain't high(as in above the tranny), I'm afraid you might have a leaking plug located on the back of the block behind the torque converter.
That's what I am thinking too. I have a leaking one behind the pass. side motor mount. Any good ideas on changing it without pulling the engine. I know I could jack the motor and pull both parts of the mount but I don't know if I would have enough room to drive in the new one.