When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
paperwork on the engine states that quench was .060 with dome .010 above deck, THEREFORE the thickness of the original gasket was .050, or would it be .060? a .050 gasket puts me at 10.07:1
10:1 is streetable, but, you will need to run high octane fuel. With a good tune, 91 would probably work, but, I would really recommend 94...... if available in your area.
If you are really bored, try reading this article.
Don't spill any...... hell, ya shuffle your feet to close to that stuff and it ignites........
JP5 is kerosene based- and has a high flash point so as to be safer in large quantities.. the military- always following 'keep it simple stupid' made it to be a less volatile fuel..
ANFO, though- that there is some BAD **** stuff..
Hey Matty- If you run ANFO in that thing, will you promise to take pictures? That rig would be like the Darwin recipient who careened into the mountain with a rocket attached to his car- you'll haul *** man, and your hp/tq will be off the charts.. but only for a few seconds I fear..