When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
i just noticed this after replacing a brake line from the front to the back of the truck, when taking off in first gear when it gets ready to shift the rpms go up slightly and the truck very slightly jerks, also when under heavy throttle the it wont downshift, if i floor it it will only reach 2500 rpms and it just feels like something is holding it back any help is greatly appreciated
Did you unplug something on the trans by accident or disconnect a cable and not put it back? Go back over everywhere you pulled, pushed while routing the line.
i was never near the transmission, i ran the line down the drivers side where the stock one ran, the only thing i can think of was i had to get close to i think the shift linkage for the column shifter i will go out and look it over though
Check TV cable and make sure you did not disrupt it when running new line. After that, check TV adjustment just to make sure and eliminate it as a possibility.
Found the problem, the plastic clip that connects the tv cable to the tb was complete busted and the tv cable wasn't even connected, do you know where I could get a new one at? I can't find one on any of the auto parts websites