When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Neat! What do ya think of it? Does it do a good job? (pic is a bit small, and my eyes are terrible. )
I really like it! I never used one. It's all in the prep work. It turned out good. I touched it to soon and messed up the finish I'll post another picture here in a few
And you can tint that any color ya want? Is that the three step version? (base, metal spray, clear coat?)
Yes any color (even Purple ). You can do it like that it there is another part to do it by chemicals. My sand blaster messed up (working on that now) or the thermostat housing would have came out better
I got the crank back and installed it last night. It's awful tight and I have no clue why. A spring and retainer went flying through the garage and lost that. So either have to try and find it or order new ones if you can just get 1 of each. Other than that the heads are done and the intake is done. A cam bearing is bad so I'm going to replace just that one as the rest are in good shape.
I believe it is normal, just have to break it in. We'll know if she blows . Ran into another problem 2 cam bearings are shot so I have to rig a tool to install the bearings