When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
94 ram won't start after crank position sensor change
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Pull the coil wire from the distributor, put a spark plug in it, ground it where you can see it, crank the engine. Do you see spark?
Ok I'll check that later today. I also saw the similar thread the forum linked and someone changed their pickup plate in the distributor and everything ran fine after thay so maybe I'll try that as well
Ok I'll check that later today. I also saw the similar thread the forum linked and someone changed their pickup plate in the distributor and everything ran fine after thay so maybe I'll try that as well
On the magnum engines, the sensor in the distributor has nothing to do with spark..... It's all about injector timing, and it is only used at startup.