What Did You Do To Your 2ND GEN RAM Today?
#7311
#7314
Changed the discs, inner wheel bearings, and pads. Brand new JVC speakers in the front, and I cleaned it out I also made a walkaround video
https://www.youtube.com/watch?v=GBRa...1&feature=plcp
https://www.youtube.com/watch?v=GBRa...1&feature=plcp
#7316
I didn't know I had these other pictures. Short term memory thang, maybe.
Ran out of gas and just used flux core.
These should give you good idea of what was done.
The gussets have a backing plate that is not shown so top is completely tied in.
A little more to do though.
#7317
yanked the stock fuel lines out, and found out Dodge got me the wrong return fuel line. They got me one for a long bed, and I have a short bed 1' too long.
(quick connect is broken that hooks to the fuel canister for factory return line, hence replacement. also no longer need stock feed line as I have an aftermarket fuel system...return line is still needed though.)
(quick connect is broken that hooks to the fuel canister for factory return line, hence replacement. also no longer need stock feed line as I have an aftermarket fuel system...return line is still needed though.)
#7320
When I built my truck I had to replace all brake shoes rotors and one caliper. Every since then , my rear brakes have squeeked at slow speed.. "VERY ANNOYING" , yesterday I purchased new shoes for the rear . After removing the shoes on the driver side rear , I noticed the top tab "CLIP" was rubbing the rotor..Bent it back out put old shoes back in and got my $57.00 back.. No more noise. Savin the change..
Last week after searching 6 months I finally found a Fiberglass Tonnoau cover .. A leer 800 for $400. Bucks with Keyless entry..I Love it !!!
Last week after searching 6 months I finally found a Fiberglass Tonnoau cover .. A leer 800 for $400. Bucks with Keyless entry..I Love it !!!