Dana 60 Swap!
Oct 26, 2013 | 12:31 PM
Joined: Oct 2009
Posts: 4,717
Likes: 10
From: N/A
^^^ The 60 has four bolts but yep you are right, 3lb hammer nope bigger 10lbs. The 44 are much ezer to do then the 60's those bolts are in the knuckle much deeper, hence the extension and the socket.
Oct 26, 2013 | 12:40 PM
Thread Starter
|
Champion
Joined: Aug 2011
Posts: 4,072
Likes: 7
From: Blacksburg, VA
Oh the backside, that makes much more sense
Last edited by Ham Bone; Oct 26, 2013 at 12:42 PM .
Oct 26, 2013 | 02:35 PM
Joined: Apr 2010
Posts: 87,464
Likes: 4,219
From: Clayton MI
Quote:
Originally Posted by
Ham Bone
Oh the backside, that makes much more sense
Lucky......
Oct 26, 2013 | 04:47 PM
Thread Starter
|
Champion
Joined: Aug 2011
Posts: 4,072
Likes: 7
From: Blacksburg, VA
Still fighting the other side...
Oct 26, 2013 | 08:22 PM
Joined: Sep 2011
Posts: 3,891
Likes: 8
From: NorCal
Alot of whining going on for these axles. :P
Oct 26, 2013 | 08:46 PM
Thread Starter
|
Champion
Joined: Aug 2011
Posts: 4,072
Likes: 7
From: Blacksburg, VA
Quote:
Originally Posted by
Wh1t3NuKle
Alot of whining going on for these axles. :P
It's frustrating! But worth it. After I get the front done and painted the rear will be a breeze, then it's buy parts and put them in!
Oct 27, 2013 | 10:14 AM
Joined: Sep 2011
Posts: 3,891
Likes: 8
From: NorCal
Oct 27, 2013 | 11:15 AM
Thread Starter
|
Champion
Joined: Aug 2011
Posts: 4,072
Likes: 7
From: Blacksburg, VA
I can't get the lower ball joint off. How is it supposed to press out?
And no I haven't gotten to it yet today
Oct 27, 2013 | 11:27 AM
Joined: Sep 2011
Posts: 3,891
Likes: 8
From: NorCal
It gets pressed up. Meaning it goes towards the knuckle. FSM page 2-10.
Do you have a Harbor Freight near you? You can get their BJ press and use it? I'm assuming you don't have a press....?
You must be having hard time keeping the axle from moving too?
Oct 27, 2013 | 11:34 AM
Thread Starter
|
Champion
Joined: Aug 2011
Posts: 4,072
Likes: 7
From: Blacksburg, VA
Upwards? So toward the upper ball joint?
