When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Have you tried any of things that have been suggested?
I havent checked the cat yet, but the dizzy is on correctly. What else can i check?
Does anyone know how to actually make it set the fuel sync, instead of just watching it on a solus pro?
That IS the correct method. Being your readings were between 0 and -2, that falls into the acceptable range. (+ or - 7 degrees) You 'set' it, by moving the dist. You don't need to do that.
What EXACTLY is happening at 3K RPM? Does it pop and sputter? Does it act like it is bouncing off the rev limiter? What?
That IS the correct method. Being your readings were between 0 and -2, that falls into the acceptable range. (+ or - 7 degrees) You 'set' it, by moving the dist. You don't need to do that.
What EXACTLY is happening at 3K RPM? Does it pop and sputter? Does it act like it is bouncing off the rev limiter? What?
Its like it just hits a wall, at around 2.5k rpm it starts getting slower, and at 3k rpm it growns and just stops reving any higher. The truck has very little power, and if you go WOT while underload (like going up hill) it just growns and doesnt pick up speed.
Also, do these trucks have a park/ neutral rev limiter?