Electric Rear Slider
#1
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
http://www.truckininstyle.com/Index.htm
Has anyone use one of these from this company? Any info would be appreciated!
Has anyone use one of these from this company? Any info would be appreciated!
#2
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
I bought one about 2 years ago. Still holding up fine with no issues.
Here is what you have to do...
Remove the back seat. (the hardest part of the whole job.)
Remove the OEM window and cleanup the glue as much as you can.
Put down the glue primer and lay down a bead of caulk and fit the new window in.
Finished with window install.Reinstall the seat. 24 hour cure time.
While that is drying, you can mount the motor behind the back seat, against the wall and connect your push pull cable.
Last, Route the wires along the drivers side to the emergency brake. Route the power and ground through the bulkhead to the battery. Tie it all up nice and pretty and mount the switch. Done
Here is what you have to do...
Remove the back seat. (the hardest part of the whole job.)
![](https://photos-f.ak.fbcdn.net/hphotos-ak-ash1/hs449.ash1/24758_1366937977489_1352869220_31043961_4774845_n.jpg)
Remove the OEM window and cleanup the glue as much as you can.
![](https://photos-b.ak.fbcdn.net/hphotos-ak-ash1/hs449.ash1/24758_1366938057491_1352869220_31043963_3074834_n.jpg)
Put down the glue primer and lay down a bead of caulk and fit the new window in.
![](https://hphotos-snc3.fbcdn.net/hs429.snc3/24758_1366938137493_1352869220_31043965_7487607_n.jpg)
![](https://photos-g.ak.fbcdn.net/hphotos-ak-snc3/hs409.snc3/24758_1366938177494_1352869220_31043966_7569820_n.jpg)
Finished with window install.Reinstall the seat. 24 hour cure time.
![](https://photos-a.ak.fbcdn.net/hphotos-ak-snc3/hs409.snc3/24758_1366938217495_1352869220_31043967_3548609_n.jpg)
While that is drying, you can mount the motor behind the back seat, against the wall and connect your push pull cable.
![](https://photos-c.ak.fbcdn.net/hphotos-ak-ash1/hs449.ash1/24758_1366938337498_1352869220_31043970_477978_n.jpg)
Last, Route the wires along the drivers side to the emergency brake. Route the power and ground through the bulkhead to the battery. Tie it all up nice and pretty and mount the switch. Done
![](https://photos-b.ak.fbcdn.net/hphotos-ak-ash1/hs449.ash1/24758_1366938257496_1352869220_31043968_6731254_n.jpg)
#7